Skip to content
Georgetown Handyman Pros

Refrigerator Repair in Georgetown, TX

Fridges that won't stay cold, freezers icing over, and ice makers that quit — defrost systems, evaporator fans, door seals, and water valves diagnosed and repaired.

Call (737) 215-4114

Typical range: $180–$450 · Free written estimate first

Refrigerator Repair in Georgetown, TX

A refrigerator is the one appliance that can’t wait. When it stops holding temperature you’re on a clock measured in hours, and the panic decision people make is usually to go buy a new one.

It’s worth a diagnosis first. The failures that actually cause “my fridge won’t stay cold” are, in our experience, far more often fans, defrost components, seals, and dirty coils than they are dead compressors — and those are all repairs that cost a small fraction of a replacement.

The Faults We See Most

  • Runs constantly but won’t hold temperature — condenser coils packed with dust and pet hair, or a failed condenser fan.
  • Freezer cold, fridge warm — evaporator fan failure or a stuck damper between the compartments. An airflow problem, not a refrigerant problem.
  • Ice sheeting up in the freezer — defrost heater, defrost thermostat, or control board no longer running the defrost cycle.
  • Water pooling under the crispers or on the floor — clogged defrost drain line.
  • Ice maker stopped — water inlet valve, frozen fill tube, or an overdue water filter.
  • Loud humming, buzzing, or rattling — a condenser or evaporator fan motor on its way out.
  • Running more than it used to — worn or torn door gaskets letting warm air in. Cheap part, real difference.

Start With the Cheapest Thing: The Coils

Before we quote a repair, we look at the condenser coils, because a surprising share of “my refrigerator is dying” calls end there.

Those coils are how your fridge dumps heat. When they’re blanketed in dust and pet hair — and behind or beneath a refrigerator that hasn’t been moved in six years, they always are — the unit can’t shed heat efficiently. So it runs longer and longer to hold the same temperature, works itself hard, and eventually loses the fight on a hot day.

Cleaning them is not a glamorous repair. It is frequently the whole fix, and it’s the first thing we check rather than the last.

The Georgetown Garage Refrigerator Problem

This one is specific to living in Central Texas, and we get the call every summer.

A lot of homes here keep a second refrigerator or freezer in the garage — the drinks fridge, the overflow freezer. Most standard refrigerators are designed to operate within a fairly narrow range of ambient temperatures, and an uninsulated Georgetown garage in July is comfortably outside it. When the air around the unit is hotter than the machine was engineered for, the thermostat logic gets confused, the compressor can’t shed heat, and the unit either runs nonstop or quietly stops cooling the freezer side.

If that’s your situation, the honest answer usually isn’t a repair. It’s that the appliance is being asked to do something it wasn’t built for, and the fix is either a garage-rated unit or a better location. We’d rather tell you that than charge you for diagnosing a machine that’s working exactly as designed.

Where We Stop — and Why That Protects You

There’s a hard line in refrigerator work and we respect it.

The sealed refrigerant system — the compressor, the refrigerant lines, the evaporator and condenser coils that carry refrigerant — requires EPA Section 608 certification to service, by law. We don’t hold that certification, so we don’t open that system. Full stop.

What we do handle is everything outside it: fans, defrost components, thermostats and sensors, door seals, drain lines, water valves, ice makers, and coil cleaning. That covers the large majority of refrigerator faults. If your diagnosis lands on the sealed side, you’ll get a straight answer and a referral, not a guess.

Repair or Replace?

Our honest framing: if the failure is a fan, a defrost component, a drain, a seal, a valve, or a control board on a refrigerator under roughly ten to twelve years old, repair almost always wins on cost. If it’s a genuine sealed-system or compressor failure on a unit already past a decade, replacement is usually the better use of your money — and we’ll say so plainly.

You’ll get the diagnosis either way, including when the diagnosis doesn’t end in us doing a repair.

Upfront Pricing

Most refrigerator repairs in Georgetown run $180–$450, parts and labor included, with a flat price quoted after diagnosis and before any work begins.

If the laundry room needs attention too, we can handle the dryer and the washer on the same trip — it’s the best value you’ll get out of a service call. See all of our appliance repair services in Georgetown.

Fridge not holding temperature? Call today — this is the one that can’t wait until next week.

Refrigerator Repair — free estimate for Georgetown

Talk to the person who'll actually do the work — not a call center. Free estimates for Georgetown and surrounding areas.

Call (737) 215-4114

Refrigerator Repair — Common Questions

+ My fridge is running but not staying cold. Is that a dead compressor?

Usually not, and that's the good news. A refrigerator that runs constantly but won't hold temperature is far more often a dirty condenser coil, a failed condenser or evaporator fan, or a defrost system that's iced over and blocked the airflow. A genuinely dead compressor is much rarer than people fear. We diagnose which it is before anyone starts talking about a new refrigerator.

+ The freezer is fine but the fridge section is warm.

That's a classic airflow fault, not a cooling fault. On most modern refrigerators the cold air is made in the freezer and blown into the fridge compartment. When the evaporator fan fails or the damper between the two sticks, the freezer stays cold and the fridge slowly warms up. It's a well-defined repair with a well-defined part.

+ There's a sheet of ice building up in my freezer.

That's the defrost system. Your freezer is supposed to melt off frost automatically on a cycle, and when the defrost heater, the defrost thermostat, or the control board quits doing it, frost accumulates until it blocks the airflow — which is usually when the fridge section starts getting warm too. It's one of the most common refrigerator repairs we do, and it's very fixable.

+ Why is there water pooling inside the fridge or under it?

Almost always a clogged defrost drain. The water that melts during each defrost cycle is supposed to run down a small tube into a pan near the compressor and evaporate. When that tube clogs — usually with debris or an ice plug — the water backs up and ends up under your crisper drawers or on the floor. Clearing it is a straightforward repair.

+ My ice maker stopped working.

The usual suspects are the water inlet valve, a frozen fill tube, or a water filter that's overdue. That last one matters more here than in other parts of the country, because hard Central Texas water shortens filter life and leaves scale in the valve. We'll find which link in that chain failed rather than replacing the whole ice maker on spec.

+ Is there refrigerator work you won't do?

Yes, and it's an important line. We don't touch the sealed refrigerant system — the compressor, the refrigerant lines, and the coils that carry them. Working on that legally requires EPA Section 608 certification, and we don't hold it. If your diagnosis lands there, we'll tell you honestly and point you to a certified tech instead of taking a swing at it.

(737) 215-4114

Free Estimates • Upfront Flat-Rate Pricing • Georgetown, TX